2010 Yamaha Motorsports TMAX Owners Manual - Page 74

PERIODIC MAINTENANCE AND ADJUSTMENT To store the battery 1. If the vehicle will not be used for more than one month, remove the battery, fully charge it, and then place it in a cool, dry place. NOTICE: When removing the battery, be sure the key is turned to "OFF", then disconnect the negative lead before disconnecting the positive lead.[ECA16302] 2. If the battery will be stored for more than two months, check it at least once a month and fully charge it if necessary. 3. Fully charge the battery before installation. 4. After installation, make sure that the battery leads are properly connected to the battery terminals. ECA16530 EAU45044 Replacing the fuses The main fuse and the fuse box, which contains the fuses for the individual circuits, are located under panel B. (See page 7-8.) 1. Remove panel B. (See page 7-8.) 2. Remove the rubber cover shown by removing the quick fasteners. 1 1 2 3 1. Battery 2 3 1 4 5 6 7 8 9 To charge the battery Have a Yamaha dealer charge the battery as soon as possible if it seems to have discharged. Keep in mind that the battery tends to discharge more quickly if the vehicle is equipped with optional electrical accessories. ECA16520 1 2 NOTICE To charge a VRLA (Valve Regulated Lead Acid) battery, a special (constant-voltage) battery charger is required. Using a conventional battery charger will damage the battery. If you do not have access to a constant-voltage battery charger, have a Yamaha dealer charge your battery. 1. Quick fastener 2. Rubber cover NOTICE Always keep the battery charged. Storing a discharged battery can cause permanent battery damage. If a fuse is blown, replace it as follows. 1. Turn the key to "OFF" and turn off the electrical circuit in question. 2. Remove the blown fuse, and then install a new fuse of the specified amperage. WARNING! Do not use a fuse of a higher amperage rating than recommended to 7-29