2009 Yamaha Motorsports RS Vector GT Owners Manual - Page 28
2009 Yamaha Motorsports RS Vector GT Manual
Page 28 highlights
Control functions ESU10993 ESU11053 Adjusting the rebound damping force of the rear shock absorber EWS00160 Adjusting the control rod The weight transfer can be adjusted by turning the adjuster on the control rod. 1. Check the control rod length using the scale on the special wrench as shown. WARNING Do not turn the remote adjustment dial while the snowmobile is moving as this could cause loss of control, an accident, and injury. ECS00290 3 1 NOTICE Be sure to stop the remote adjustment dial at a marked position around the dial where there is a click. The rebound damping force can be adjusted by turning the rear shock absorber damping force remote adjustment dial. To increase the rebound damping force, turn the adjusting dial in direction (a). To decrease the rebound damping force, turn the adjusting dial in direction (b). 1. Special wrench 2. Control rod length 3. Scale range 2 TIP Use the special wrench in the owner's tool kit to make this adjustment. 2. Loosen the locknut. 2 (b) (a) 1 1. Rear shock absorber damping force remote adjustment dial 2. Standard position Rebound damping setting: Minimum (soft): 11 click(s) in direction (b)* Maximum (hard): 11 click(s) in direction (a)* * With the adjustment dial in the standard position 1. Locknut 2. Control rod adjuster 3. To increase weight transfer, turn the adjuster in direction (a), and to decrease weight transfer, turn it in direction (b). WARNING! Never adjust the control rod beyond the range of the scale on the special wrench, otherwise the con- 22