1998 Oldsmobile Bravada Owner's Manual - Page 276

Front Turn Signal Lamps 1. Remove the headlamp assembly as shown earlier in this section. 2. Twist the bulb socket to remove it from the headlamp assembly. 3. Pull the bulb straight out to remove i t from the socket. 4. Push the new bulb into the socket until it snaps into place. Taillamps 1. Open the endgate. 2. Remove the two screws from the lamp assembly. 5. Put the bulb socket into the lamp assembly and twist it to the right until it is tight. 6. Put the headlamp assembly back into the vehicle. Instill the two retaining clips. 1 3. Pull the assembly away from the vehicle. 4. Turn the socket to the left to remove it. Push the ta in while you turn the socket to the left. 5 . Holding the base of the bulb, pull the bulb straight out of the socket. 6. Push the new bulb straight into the socket until it clicks. 7. Put the socket into the lamp assembly and turn the socket to the right ~ l n t i lit locks into place. 8. Install the lamp assembly and screws. 9. Close the endgate. 6-34