1998 Oldsmobile Bravada Owner's Manual - Page 113

To program a garage door opener with the rolling code feature, do the following: 1. Program your hand-held transmitter to the universal transmitter by following the steps provided under "Programming the Transmitter" earlier in this section. 5 . Return to your vehicle and press the programmed button on the universal transmitter until the red light flashes rapidly (about two seconds). 6. Release the button, then press it again to confirm it was programmed to the garage door opener receiver. You may now use either the universal transmitter or the hand-held transmitter to open your garage door. If you still have difficulty in programming and require assistance, please call 1-800-355-35 15. 2. Remove the cover panel ,from the garage door opener receiver. It is located near the garage door opener motor. 3. Locate the training button on the garage door opener receiver. The exact location and color will vary among brands. Accessories Accessories for the universal transmitter are available from the manufacturer of the unit. If you would like additional information, please call 1-800-355-35 1.5. 4. Press the training button on the garage door opener receiver for one to two seconds. 2-49