1993 Oldsmobile Silhouette Owner's Manual - Page 135
1993 Oldsmobile Silhouette Manual
Page 135 highlights
5. Press SET and 000 will appear on the display. 6. Press and holdSEEK until the first digit of your code appears. 7. Press and hold SCAN until the second and third digits your code of appear. 8. Press AM/FM and 000 will appear again. Now you are ready to enter the last three digits of your code. 9. Repeat steps 6 and 7 for the last three digits of your code. 10. Press AM/FM and rEP will appear. 11. Repeat steps 6 through 10. This time SEC will appear, indicating thatthe radio is secure. If appears, the steps were not successful and you must repeat the entire procedure. To Unlock the System After a Power Loss: When battery power is reapplied to a secured radio, the radio won't turn on and LOC will appear on the display. Enter your secret code as follows; pause no more than 15 seconds between steps. 1. Turn the ignition on. (Radio off.) 2. Press the SET button. The display will show 000. 3.Enter the six digits of the code following steps 6-9 above. The display will show the numbers as entered. 4. Press the AM/FM button and the time appears, indicating that the disabling sequence was successful. If the display indicates SEC, the numbers did not match and unit is the still secured. Disabling the Anti-Theft System: 1. Press PREV and FF together for five seconds with the ignition on and radio power off. The display will show SEC, indicating the unit is in the secure mode. (If appears on the display, the anti-theft system has already beendisabled.) 2. Press the SET button. The display will show 000. 3.Enter the first three digits of the code following steps6 and 7 of the preceding paragraphs. The display will show the numbers as entered. 4. Press AM/FM. The radio will display 000. 5. Repeat steps6 and 7 to enterthe second three digits of the code. The display will show the numbers as entered. 6. Press AM/FM. If - -" then the time appears, the disabling sequence was successful (the numbers matched the secret code) and the unit is in the UNSECURED mode. If the display shows SEC, the disabling sequence was unsuccessful (the numbers did not match) and the unit will remain in the SECURED mode. bb- 133