2014 Honda CR-V 2014 CR-V Navigation Manual - Page 181

TroubleshootingMiscellaneous Questions Miscellaneous Questions Problem Solution My clock frequently changes forward and backward by The clock setting is automatically updated based on your GPS location. If you live and one hour. work on the boundary between two time zones, you can turn off this feature. 2 Clock Adjustment P. 47 The clock changes even when I am not driving near a time zone boundary. The time zone boundaries are only approximated in the navigation system. Depending on the geography of the time zone boundary, the switch to a different zone can be erratic. 2 Clock Adjustment P. 47 Press the INFO button. Select Setup > Other > Clock Adjustment > Clock Adjustment, and set Auto Daylight to Off. 2 Clock Adjustment P. 47 The automatic daylight saving time feature does not work in regions where the daylight saving time system has not been adopted. Press the INFO button. Select Setup > Other > Clock Adjustment > Clock Adjustment, and set Auto Daylight to On. Note that the automatic daylight feature does not work in regions where the daylight saving time system has not been adopted. 2 Clock Adjustment P. 47 You may be driving near a time zone boundary. 2 Clock Adjustment P. 47 Press and hold the VOL 9 (Volume/Power) button for two seconds. The system should reactivate. If you have installed an aftermarket system, see your dealer. 2 Entering the Security Code P. 186 Press the INFO button. Select Setup > Other > Language, and set the language to English, Français, or Español. My state does not observe daylight saving time. How do I turn off this feature? Daylight saving time has started, but the navigation system did not change time even though Auto Daylight is set to ON. The navigation system automatic daylight feature is not switching the navigation system clock on the correct dates. 180 Troubleshooting The navigation system clock switched by one hour for no apparent reason. My battery was disconnected or went dead, and the navigation system is asking for a code. How do I change the interface language?