Sanyo PLC-XM100/L RS232C Expand - Page 16

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications CR_P-MANETIME [CR] CR_STANDBYMODE [CR] CR_ON-STA [CR] CR_POINTER[CR] CR_PTIMEMODE[CR] CR_PTIMER[CR] CR_PTIME[CR] CR_KEYDIS [CR] CR_SECURITY [CR] CR_PJLOCKNOW [CR] CR_PJLOCKMENU [CR] CR_SHUTRCPROT[CR] CR_SHUTKEYPROT[CR] CR_SHUTH[CR] CR_DELAYCTRL[CR] CR_TESTPAT[CR] Get setting time for Power Management Get selected mode of Standby function Get ON Start setting status Get setting status of Pointer Get setting mode of P-timer Get status of P-timer Get setting time for count down mode in P-timer Get RC/KEY prohibited status Get setting status of Security Get setting status of current PJ Lock Get PJ Lock setting status on the menu Get remote controller disability status of the shutter Get Key controller disability state of the shutter Get time setting to begin the shutter management Get selected mode of Video delay control Get setting status of Test pattern 6.9 Other Status Read Command Table Status Read command CR_STATUS [CR] CR_SIGNAL [CR] CR_VMUTE [CR] CR_FREEZE [CR] CR_TEMPFAIL [CR] CR_TEMP [CR] CR_SHUTCOND [CR] CR_SERIALNO [CR] Item Get operating status of Projector Get status of signal existence Get setting status of No show Get setting status of Freeze Get temperature when sensors approach abnormal temperature Get current temperature Get setting status of Shutter Get value of SERIAL NO. 7． Error Code Table Error Code ? 000 101 Contents -When the received data cannot be decoded -Parameter designation error (wrong digit number, including invalid value, etc.) Normal reception (This is "Not" error) The function is not available in the selected Mode 102 Selected value is out of range (Not reflected) 103 Command mismatched to Hardware (the command is for Optional function which is not implemented) 201 Incremented or decremented value or values are beyond upper or lower limits. 301 Not executable due to screen capturing in process. Prompting reissue of the command after a while. 402 Not executable due to PIN code in operation. Prompting reissue of the command after a while. Note) These error codes are applied to Expand Command, not to Basic Command 16/79