Netgear UTM25S Reference Manual 3.0.1-124 - Page 500

ProSecure Unified Threat Management (UTM) Appliance View the VPN Tunnel Connection Status To review the status of current IPSec VPN tunnels, select Monitoring > Active Users & VPNs > IPSec VPN Connection Status. The IPSec VPN Connection Status screen displays: Figure 291. The Active IPSec SA(s) table lists each active connection with the information that is described in the following table. The default poll interval is 5 seconds. To change the poll interval period, enter a new value in the Poll Interval field, and then click Set Interval. To stop polling, click Stop. Table 129. IPSec VPN Connection Status screen information Item Policy Name Endpoint Tx (KB) Tx (Packets) State Action Description The name of the VPN policy that is associated with this SA. The IP address on the remote VPN endpoint. The amount of data that is transmitted over this SA. The number of IP packets that are transmitted over this SA. The status of the SA. Phase 1 is the authentication phase, and Phase 2 is key exchange phase. If there is no connection, the status is IPSec SA Not Established. Click the Connect table button to build the connection, or click the Disconnect table button to terminate the connection. To review the status of current SSL VPN tunnels, select Monitoring > Active Users & VPNs > SSL VPN Connection Status. The SSL VPN Connection Status screen displays: Monitor System Access and Performance 500