Netgear UTM10EW3-100NAS Reference Manual 3.0.1-124 - Page 495
Table 127., Detailed Status screen fields, Description, LAN Port Configuration, WAN Info
View all Netgear UTM10EW3-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 495 highlights
ProSecure Unified Threat Management (UTM) Appliance The following table explains the fields of the Detailed Status screen: Table 127. Detailed Status screen fields Item Description LAN Port Configuration The following fields are shown for each of the LAN ports. VLAN Profile VLAN ID The name of the VLAN profile that you assigned to this port on the LAN Setup screen (see Assign and Manage VLAN Profiles on page 100). If the VLAN is not enabled on this port, the default profile (with VLAN ID 1) is assigned automatically. The VLAN ID that you assigned to this port on the Add VLAN Profile screen (see Configure a VLAN Profile on page 103). If the default VLAN profile is used, the VLAN ID is 1, which means that all tagged and untagged traffic can pass on this port. MAC Address The MAC address of this port. All LAN ports share the same MAC address if they are part of the default VLAN. However, if LAN port 4 (UTM5, UTM10, UTM25, and UTM150) or LAN port 6 (UTM50) is enabled as the DMZ port, its MAC address is changed to the MAC address of the WAN2 interface plus 1. (For example, if the MAC address of the WAN2 interface is 00:26:f2:b5:db:80, the MAC address of the DM port is 00:26:f2:b5:db:81.) For information about configuring the DMZ port, see Configure and Enable the DMZ Port on page 117. IP Address Subnet Mask The IP address for this port. If the VLAN is not enabled on this port, the IP address is the default LAN IP address (192.168.1.1). For information about configuring VLAN profiles, see Configure a VLAN Profile on page 103. The subnet mask for this port. If the VLAN is not enabled on this port, the subnet mask is the default LAN IP subnet mask (255.255.255.0). For information about configuring VLAN profiles, see Configure a VLAN Profile on page 103. DHCP Status The status can be either DHCP Enabled or DHCP Disabled. For information about enabling DHCP for this port, see Configure a VLAN Profile on page 103. WAN Info, xDSL information in SLOT-1 Info or SLOT-2 Info, and USB Info Note: For the UTM9S and UTM25S only: DSL information is shown in the SLOT-1 Info or SLOT-2 Info section, depending on the slot in which the xDSL network module is installed. All other fields that are shown in the SLOT-1 Info or SLOT-2 Info section are also shown in the WAN Info sections. Note: The USB information in the USB Info section applies to the UTM9S and UTM25S only. The following fields are shown for each of the WAN ports and for the slot in which the xDSL network module is installed: WAN Mode The WAN mode can be Single Port, Load Balancing, or Auto Rollover. For information about configuring the WAN mode, see Configure the WAN Mode on page 80. Card Type (UTM9S and The configuration of the xDSL network module: VDSL or ADSL. UTM25S only) Daughter Card (UTM9S The type of supported annex on the xDSL network module: Annex A or Annex B and UTM25S only) (VDSL_ANNEXA, VDSL_ANNEXB, ADSL_ANNEXA, or ADSL_ANNEXB). Monitor System Access and Performance 495