Netgear UTM10EW3-100NAS Reference Manual 3.0.1-124 - Page 349
Destination Network and Subnet Mask fields; otherwise, the SSL, VPN > SSL VPN > SSL VPN Client
View all Netgear UTM10EW3-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 349 highlights
ProSecure Unified Threat Management (UTM) Appliance WARNING: Do not enter an existing route for a VPN tunnel client in the Destination Network and Subnet Mask fields; otherwise, the SSL VPN Wizard fails when you attempt to apply the settings and the UTM reboots to recover its configuration. Table 91. SSL VPN Wizard Step 4 of 6 screen settings (client addresses and routes) Setting Description Client IP Address Range Enable Full Tunnel Support Select this check box to enable full-tunnel support. If you leave this check box cleared (which is the default setting), full-tunnel support is disabled but split-tunnel support is enabled, and you need to add a client route by completing the Destination Network and Subnet Mask fields. DNS Suffix Note: When full-tunnel support is enabled, client routes are not operable. A DNS suffix to be appended to incomplete DNS search strings. This setting is optional. Primary DNS Server The IP address of the primary DNS server that is assigned to the VPN tunnel clients. This setting is optional. Note: If you do not assign a DNS server, the DNS settings remain unchanged in the VPN client after a VPN tunnel has been established. Secondary DNS Server The IP address of the secondary DNS server that is assigned to the VPN tunnel clients. This setting is optional. Client Address Range Begin The first IP address of the IP address range that you want to assign to the VPN tunnel clients. Client Address Range End The last IP address of the IP address range that you want to assign to the VPN tunnel clients. Add Routes for VPN Tunnel Clients Destination Network Leave this field blank, or specify a destination network IP address of a local network or subnet that has not yet been used. This setting applies only when full-tunnel support is disabled. Subnet Mask Leave this field blank, or specify the address of the appropriate subnet mask. This setting applies only when full-tunnel support is disabled. After you have completed the steps in the SSL VPN Wizard, you can change the client IP address range and routes by selecting VPN > SSL VPN > SSL VPN Client. For more information about client IP address range and routes settings, see Configure the SSL VPN Client on page 365. Virtual Private Networking Using SSL Connections 349