Intermec CV30 Intermec Terminal Emulator (ITE) Programmer's Reference Manual - Page 93

Chapter 2 - About VT/ANSI Programming Local Edit Mode Keys (continued) Keys Remove Prev screen Next screen Select Backspace Delete A-Z, 0-9, Auxiliary keypad Back Tab Cursor s t [R] [L] Function If in protected area, computer emits beep and cursor advances to first position of next selectable field. If not found, it advances to bottom margin (default is Row 24, Column 80). If in unprotected field, it is cleared and the cursor is positioned to the beginning of the selectable field. Ignores these keys. Moves cursor one position to the left until it reaches the left margin. Deletes the previous selectable character. If a key is pressed while in a protected area, computer emits beep, advances cursor to next selectable field, enters characters. If field not found, cursor advances to bottom margin. Cursor moves back to the first occurrence of the following: • Previous tab stop. • Beginning of the current unprotected field. • Beginning of the previous unprotected field. • Beginning of scrolling region. (Also called top margin.) Cursor moves up one line until it reaches the top margin. The computer beeps when the cursor reaches the top margin. Cursor moves down one line until it reaches the bottom margin. The computer beeps when the cursor reaches the bottom margin. Cursor moves right one character position until it reaches the right margin. The computer beeps when the cursor reaches the right margin. Cursor moves left one character position until it reaches the left margin. The computer beeps when the cursor reaches the left margin. Scanning in Local Edit Mode When scanning is enabled, data from the scanner is placed into the field where the cursor is located. If the cursor is not in an input field, the data from the scanner is placed into the next input field. If scanner data fills the first input field, remaining characters are placed into the next input field. When the bar code does not fill the input field, the cursor stays where it ended. If autotab scanning is enabled, the cursor is placed at the beginning of the next input field. If that field is not found, extra data is lost. Set Transmit Termination Character (DECTTC) The computer supports the set transmit termination character (DECTTC) control function. Use the control function to select a character to indicate the end of a block transmission. You do not need to use an end-of-block character. The computer sends the end-of-block character to the host at the end of each block transmission. The control sequence is: CSI Ps | Intermec Terminal Emulator (ITE) Programmer's Reference Manual 81