Intermec CV30 Intermec Terminal Emulator (ITE) Programmer's Reference Manual - Page 111

Chapter 3 - Extended Commands 3270 and 5250 Data Streams Column Description Character 2 3 4 5 6 7 8 9 10 11-12 13 14-15 16-17 18-19 20-21 22 23 24-25 Begin extended command # Receive Only on G RS-232 Port command Speed (bits per second) 1=1200; 2=2400; 3=4800; 4=9600; 5=19200; 6=38400; 7=57600; 8=115200 Data parity N=None; 0 (zero)=None; b=None; E=Even; O=Odd Data bits 7=Seven; 8=Eight Stop bits 1=One; 2=Two CTS flow N/A DSR flow 0=Disable; 1=Enable XON/XOFF flow control 0=Disable; 1=Enable Flow control timeout value XX=Number of seconds Return AID key b=AID key is Enter (default). X=AID key character. For return AID key characters, see "Return AID Key Characters for 3270 or 5250 Emulation" on page 88. Maximum characters to receive bb=Default dd or Xd...dX, where: dd=00-99. Default is 99. d...d=Any number of decimal digits from 0-2000, inclusive. Default is 99. Delimiter character AA=Hexadecimal ASCII code that marks the end of data to receive. Range: 00-7E. Default of 00 or bb implies no start character. Number of delimiter characters XX=Number of characters accepted before sending return code to host. Range is 00 to 99. Default of 00 or bb implies no start character. Start character AA=Hexadecimal ASCII code. Range is 00 to 99. Default of 00 or bb implies no start character. Return start character to host F=Return character; b=Do not return character Flag parity errors P=Flag; b=Do not flag Receive timeout length XX=Number of seconds the computer waits for input from the RS-232 port before it sends a timeout error. Uses 5-second default when this field contains spaces. Intermec Terminal Emulator (ITE) Programmer's Reference Manual 99