Dell Inspiron 5391 Service Manual - Page 52
Installing the display panel
View all Dell Inspiron 5391 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Steps 1. Using a plastic scribe, slide out the pull tab of the SR tape from both sides of the display panel. 2. Pull out a small section of the SR tape. 3. Roll the SR tape around the plastic scribe. NOTE: To avoid severing/breaking the SR tape, pull out only a small section of the SR tape and then roll the SR tape around the scribe. 4. Lift the display panel off the display back-cover. 5. Peel the tape that secures the display cable to the display back-cover. 6. Open the latch and disconnect the display cable from the display back-cover. Installing the display panel Prerequisites NOTE: This procedure is not applicable to computers shipped with a WWAN configuration. If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of display panel and provides a visual representation of the installation procedure. 52 Removing and installing components