2011 Yamaha Motorsports RS Vector GT Owners Manual - Page 108
2011 Yamaha Motorsports RS Vector GT Manual
Page 108 highlights
Periodic maintenance and adjustment 6. Recheck alignment and deflection. If necessary, repeat steps 3 to 5 until the proper adjustment is achieved. Lower the snowmobile to the ground. Tighten the rear axle nut. Rear axle nut tightening torque: 75 Nm (7.5 m·kgf, 54 ft·lbf) EWS00511 WARNING Do not grease the throttle cable because it could become frozen, which could cause loss of control. Apply a dab of grease onto the cable end only. 7. 8. TIP For parts equipped with a grease nipple, use a grease gun. Lubricants: Brake lever: Silicone grease Other lubrication points: Low-temperature grease Slide runners Check the slide runners for wear and damage. If the slide runners reach the wear limit, they should be replaced. 1. Slide runner 2. Wear limit height 1 1. Lubrication point Slide runner wear limit height: 10.5 mm (0.41 in) ECS00350 NOTICE Ride on fresh snow frequently. Operating on ice or hard-packed snow will rapidly wear the slide runners. ESU12198 Lubrication Lubricate the following points with the specified grease. 1. Throttle cable end 102
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80
-
81
-
82
-
83
-
84
-
85
-
86
-
87
-
88
-
89
-
90
-
91
-
92
-
93
-
94
-
95
-
96
-
97
-
98
-
99
-
100
-
101
-
102
-
103 -
104 -
105 -
106 -
107 -
108 -
109 -
110 -
111 -
112 -
113 -
114
-
115
-
116
-
117
-
118
-
119
-
120
-
121
-
122
-
123
-
124
-
125
-
126
-
127
-
128
-
129
-
130
-
131
-
132
-
133
-
134
-
135
-
136
-
137
-
138
-
139
-
140
 |
 |
