2003 Oldsmobile Bravada Owner's Manual - Page 171
2003 Oldsmobile Bravada Manual
Page 171 highlights
Finding a Station BAND: Press this button to switch between AM, and FM2. The display will show your selection. Setting Preset Stations FMl The six numbered pushbuttons let you return to your favorite stations. You can set up to 18 stations (six AM, six FMI and six FM2), by performing the following steps: 1. Turn the radio on. 2. Press BAND to select AM, FMI or FM2. TUNE: Turn this knob to select radio stations. < SEEK > : Press the right or the left arrow to go to the next or to the previous station and stay there. The radio will seek only to stations to stations that are in the selected band and only to those with a strong signal. 3. Tune in the desired station. 4. Press AUTO EQ to select the equalization that best suits the type of station selected. 5. Press and hold one of the six numbered pushbuttons until you hear a beep. Whenever you press that numbered pushbutton, the station you set will return and the equalization that you selected will also be automatically selected for that pushbutton. < SCAN > : Press and hold either arrow for two seconds until SC appears on the display and you hear a beep. The radio will go to a station, play for a few seconds, then go on to the next station. Press either SCAN arrow again to stop scanning. To scan preset stations, press and hold either SCAN arrow for more than four seconds. PRESET SCAN will appear on the display. You will hear a double beep and the P will blink with the preset number. The radio will go to the first preset station stored on your pushbuttons, play for a few seconds, then go on to the next preset station. Press either SCAN arrow again to stop scanning presets. The radio will scan only to stations that are in the selected band and only to those with a strong signal. 3-58 6. Repeat the steps for each pushbutton. Setting the Tone (BasdTreble) AUDIO: Press and release the AUDIO button until BASS, MID or TREB appears on the display. Press the knob above the AUDIO button to extend it, then turn the knob to increase or to decrease. If a station is weak or noisy, you may want to decrease the treble. Pressing and holding the AUDIO button for at least two seconds will return all tone settings, including balance and fade to flat.