2003 Oldsmobile Aurora Owner's Manual - Page 88
2003 Oldsmobile Aurora Manual
Page 88 highlights
3. If your engine still won't start (or starts but then stops), it could be flooded with too much gasoline. Try pushing your acceleratorpedal all the way to the floor and holding it there as you hold the key in START for about three seconds. If the vehicle starts briefly but then stops again, do the same thing. This time keep the pedal down for five or six seconds to clear the extra gasoline from the engine. After waiting about 15 seconds, repeat the normal starting procedure. To Use the Engine Coolant Heater 1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. The engine coolant heater cord is located on the passenger's side of the vehicle, above the headlamp assembly. 3. Plug it into a normal, grounded 110-volt AC outlet. Nofice: Your engine is designed to work with the electronics in your vehicle. If you add electrical parts or accessories, you could change the way the engine operates. Before adding electrical equipment, check with yourdealer. If you don't, your engine might not perform properly. I Plugging the cord into an ungrounded outlet could cause an electrical shock.Also, the wrong kind of extension cord could overheat and cause a fire. You could be seriously injured. Plug the cord into a properly grounded three-prong 110-voltAC outlet. If the cord won't reach, use a heavy-duty three-prong extension cord rated for at least 15 amps. 4. Before starting the engine, be sure to unplug and store the cord as it was before to keep it away from moving engine parts. If you don't, it could be damaged. 2-25 Engine Coolant Heater If your vehicle has this feature, in very cold weather, 0°F (-18°C) or colder, the engine coolant heater can help. You'll get easier starting and better fuel economy during engine warm-up. Usually, the coolant heater should be plugged in a minimum of four hours prior to starting your vehicle. At temperatures &D\!P 32°F (""c), of the con!ant heater is not required.