2003 Oldsmobile Aurora Owner's Manual - Page 122

For a single wiping cycle, move the lever down to MIST. Hold it there until the wipers start, then release it. The wipers will stop after one cycle. If you want more cycles, hold the lever on MIST longer. For steady wiping at low speed, move the lever up to the LO position. For high-speed wiping, move the lever up further, to HI. To stop the wipers, move the lever to OFF. You can set the wiper speed for a long or short delay between wiper cycles. Move the lever up to the first detent, INT (Intermittent). Turn the band labeled INT ADJ (Intermittent Adjustment) down toward the shorter lines for fewer wiper passes per minute. As you turn the band toward the longer lines, the wiper cycles per minute will increase. Remember that damaged wiper blades may prevent you from seeing well enough to drive safely. To avoid damage, be sure to clear ice and snow from the wiper blades before using them. If they're frozen to the \yindrihield, ~ ~ r ~ f ~ !lcgspn Il;/ 9~ t h l ~ ~ them. ! !f \J/ n l l r hl=dnc -' do become damaged, get new blades or blade inserts. See Windshield Wiper Blade Replacement on page 5-59. Heavy snow or ice can overload your wipers. A circuit breaker wi!! stop them unti! the mntnr con!s. C!ear away snow or ice to prevent an overload. RainsenseTMII Wipers The moisture sensor is mounted on the interior side of the windshield below the rearview mirror and is used to automatically operate the windshield wipers. This system operates by monitoring the amount of moisture build-up on the windshield. Wipes occur as needed to clear the windshield depending on the driving conditions and sensitivity setting. In light rain or snow, fewer wipes will occur. In heavy rain or snow, wipes will occur more frequently. The system will operate in the delay, low speed and high speed modes. If the system is left on for long periods of time, occasional wipes may occur without any moisture on the windshield. This is normal and indicates that the RainsenseTM system is activated. 3-9