1996 Oldsmobile Achieva Owner's Manual - Page 141
1996 Oldsmobile Achieva Manual
Page 141 highlights
SCAN: Press this button to listen to each selection for a few seconds. The tape will go to the next selection, stop for a few seconds, then go on tothe next selection. Press this button again to stop scanning. 'Thesound will be muted, SCAN will appear on the display and the tape direction arrow will blink while scanning. TONE: Press this button to select a TONE while playing a cassette. The tone will be automatically set whenever you play a cassette tape. AM-FM: Press this button to play the radio when a tape is in the player. The tape will stop but remain in the player. TAPE CD: Press this button to change to the tape function when the radio or disc function is on. A box will appear around TP on thedisplay when the tape is active. Press this button again to return to the radio or disc function. EJECT Press this button to remove the tape. The radio will play. EJECT may be activated with either the ignition or radio off. Cassettes may be loaded with the radio off if this button is pressed first. CLN: This message may appear on the display. If it does, your cassette tape player needs to be cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damage to your tapes and player. See "Care of Your Cassette Tape Player" in the Index. After you clean the player, press and hold EJECT for five seconds to reset the CLN indicator. The radio will display --- to show the indicator was reset. Playing a Compact Disc Insert a disc partway into the slot, label side up. The player will pull it in. The disc should begin playing. If you're driving on a very rough road or if it's veryhot, the disc may not play and ERR (error) may appear on the display. When things get back to normal, the disc should play. If the disc comes out, it could be that: The disc is upside down. It is dirty, scratched or wet. It is very humid. (If so, wait about an hour and try again.) RCL: Press this button to see which track is playing. Press it again within five seconds to see how long it has been playing. To change what is normally shown on the display (track or elapsed time), press the button until you see the display you want, then hold the button until the display flashes. While elapsed time is showing, EL TM will appear on the display.