1996 Oldsmobile Achieva Owner's Manual - Page 138
1996 Oldsmobile Achieva Manual
Page 138 highlights
RCL: Press this button briefly to recall the station being played or the clock display. To change what is normally shown on the display (station or time), press the button until you see the display you want, then hold the button until the display flashes. If you press the button when the ignition is off, the clock will show for a few seconds. PSCAN: Press SCAN for more than two seconds, and PSCAN will appear on the display. The radio will go to the first preset station storedon your pushbuttons, stop for a few seconds, then go on to the next preset station. Press SCAN again to stop scanning. indin- . , tation PUSHBUTTONS: The five numbered pushbuttons let you return to your favorite stations. You can set up to 15 stations (five AM,five FM1and five FM2). 1. Press AM-FM to select the band. 2. Find the station you want by usingTUNE or SEEK. AM-FM: Press this button to get AM, FM1 orFM2. The display shows your selection. TUNE: Press this knob lightly so it extends. Turn it to choose radio stations. Push the knob back in when you're not usingit. SEEK: Press the upor down arrow to go to the next higher or lower station. The sound will be muted while seeking. 3. Press TONE to select the graph that best suits the type of station selected. 4. Press and hold one of the five numbered buttons. SCAN: Press this button andrelease it to listen to stations for afew seconds. The radio will go to a station, stop for a few seconds, then go on to the next station. Press the button againto stop scanning. The sound will be muted while scanning, and SCAN will appear onthe display. If you press SCAN for more than two seconds, the radio will changeto PSCAN mode. PSCAN will appear on the display. 5. The sound will mute. When it returns, release the button. Whenever you press that numbered button, the station you set will return and the TONE equalization that you selected will also be automatically selected for that button. If you manually tune use SEEK or SCAN to find a or frequency stored in a preset, TONE equalization the stored for that frequency will not be recalled. Always check the display first to make sure you have the correct band.