2014 Ducati Superbike 1199 Panigale R Owners Manual - Page 89
2014 Ducati Superbike 1199 Panigale R Manual
Page 89 highlights
Note When the LAP function is active, the FLASH button takes on the dual function of high beam command and finish line memorization for GPS of the LAP timer (new lap start indication). - - Note The TRIP FUEL function always has top priority over the LAP function: in case of activation of the TRIP FUEL function with active LAP function, the LAP timer view is automatically removed and TRIP FUEL information is displayed instead. - LAP recording If the LAP function is active, the lap time can be recorded for a total of 30 consecutive laps. Operation: to allow the GPS to automatically identify the "Start/Stop" at every lap, the finish line coordinates must be saved by pressing the FLASH (3) button upon first crossing of the finish line. The lap timer starts with a tenth-of-a-second resolution (0'00''00); with every successive crossing of the finish line the number and time for the lap just completed is displayed for 5 seconds and with the tenth-ofa-second resolution; after these 5 seconds, the instrument panel goes back to lap timer page referred to the new current lap. if the vehicle is at a standstill for more than 5 seconds, lap timer operation is temporarily stopped and it displays the initial indication " 0'00''00 " and lap number "LAP - -"; at the next "Start" command sent by the GPS (cross of finish line) the lap timer is reactivated again. . If the time is never stopped, it will roll over upon reaching 9 minutes, 59 seconds and 99 hundredths; the lap timer starts counting from zero and will keep running until the lap is stopped or the recording function is disabled. Laps are numbered from 01 to 30 and are in a loop: after the first 30 laps the instrument panel will overwrite information starting from Lap 01. If the LAP function is interrupted (change to ROAD layout or temporary disabling or key-off) and then reactivated (back to TRACK layout or reactivation or 87