2013 Ford Taurus Owner Manual Printing 3 - Page 180

Universal Garage Door Opener (If Equipped) 179 Programming HomeLink® to the Genie Intellicode® garage door opener motor Note: You may need a ladder to access the garage door opener motor. To program HomeLink® to the garage door opener motor: 1. Press and hold the PROGRAM button on the garage door opener motor until both blue LED's turn on. 2. Release the PROGRAM button. Only the smaller round LED should be on. 3. Press and release the program button. The larger purple LED will flash Note: The next two steps must be completed in 30 seconds. 4. Press and release the Genie Intellicode 2 hand-held transmitter's previously programmed button. Both indicator lights on the garage door opener motor unit should now flash purple. 5. Press and hold the previously programmed button on the sun visor for two seconds. Repeat this step up to 3 times until the garage door moves. Programming is now complete. Clearing a HomeLink® device To erase programming from the three HomeLink® buttons, press and hold the two outer HomeLink® buttons until the indicator light begins to flash. The LED will begin flashing in 10 to 20 seconds, at which time both buttons should be released. Programming has now been erased, and the LED should blink slowly to indicate the device is in train mode when any one of the three HomeLink buttons is pressed. FCC and RSS-210 Industry Canada Compliance This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to your device not expressly approved by the party responsible for compliance can void the user's authority to operate the equipment. 2013 Taurus Owners Guide gf, 3rd Printing, December 2012 USA (fus)