2013 Ford Taurus Owner Manual Printing 3 - Page 178

Universal Garage Door Opener (If Equipped) 177 After programming the HomeLink button, follow Steps 5 - 7 as listed below to program your garage door opener. Note: You may need a ladder to reach the unit and you may need to remove the cover or lamp lens on your garage door opener. 5. Press the learn button on the garage door opener motor, and then you have 30 seconds to complete the next step. 6. Return to your car. 7. Press and hold the function button you want to program for two seconds, then release. Repeat this step. Depending on your brand of garage door opener, you may need to repeat this sequence a third time. To program additional buttons, repeat Steps 1 - 4. For questions or comments, please contact HomeLink® at www.homelink.com or 1-800-355-3515. Erasing the Function Button Codes Note: You cannot erase individual buttons. 1. Press and hold the outer two function buttons simultaneously for approximately 20 seconds until the indicator lights above the buttons flash rapidly. 2. When the indicator lights flash, release the buttons. The codes for all buttons are erased. Reprogramming a single button To program a device to a previously trained button, follow these steps: 1. Press and hold the desired button. Do NOT release the button. 2. The indicator light will begin to flash after 20 seconds. Without releasing the button, follow Step 1 in the Programming section. For questions or comments, contact HomeLink® at www.homelink.com or 1-800-355-3515. 2013 Taurus Owners Guide gf, 3rd Printing, December 2012 USA (fus)