URC URC-A6 Owners Manual - Page 26
Erasing Commands -- Overview
View all URC URC-A6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Erasing Commands -- Overview You can erase a single learned command, all learned commands in each component mode, SimpleSound programming, MacroPower commands, or re-set the remote to original factory default settings. Erasing a Single Learned Command from One Component STEP 1: Press the component button where the learned command is stored and the ENTER buttons at the same time for two seconds until the component LED light turns on. IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. COMPONENT BUTTONS ENTER STEP 2: Press and hold the button you want to erase for two seconds. The component LED light will blink twice to confirm the erasure. STEP 3: Repeat Step 2 to erase any other buttons in the selected component mode. STEP 4: To exit Erase mode, press and hold both the component button and the ENTER (ENT) button at the same time until the component LED light blinks three times. Page 26