URC URC-A6 Owners Manual - Page 11
If the Three Digit Code did not, work, try this next - remote control
View all URC URC-A6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
If the Three Digit Code did not work, try this next: Auto-Search Method The Auto-Search Method is a way you can scan through all of the codes in the table to find the right code for your component. STEP 1: Manually or using your old remote, turn on the component you want to program-for example, to program your TV, turn on your TV set. STEP 2: On the URC-A6, press the Component button that you want to program (in this case the button that says TV) and the SELECT [SEL] button at the same time. Hold down both buttons for 2 seconds until the TV Component button light turns on. This signals that you are in programming mode. IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. 5 UP ARROW 6 DOWN ARROW STEP 3: Point the URC-A6 remote control toward 5 the component and press the UP arrow (or 6 DOWN arrow) button once. Each time the UP or DOWN arrow button is pressed, the code will count up (or down) one code number and send a Power OFF signal. When the correct code is sent out, the component will turn off. Page 11