URC URC-A6 Owners Manual - Page 24

URC URC-A6 Manual

Get URC URC-A6 PDF manuals and user guides View all URC URC-A6 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

OSD (On-Screen Display) Control "Punch Through" This "Punch Through" enables you to program the URC-A6 so that CBL or DVD OSD Controls (MENU, GUIDE, INFO, EXIT, SEL and 4 Cursor Controls) will also operate in other component modes on the remote control. STEP 1: Press and hold the component button you want to add OSD Control to, such as TV or DVD, and the SELECT [SEL] button at the same time for two seconds until the Component LED light turns on. IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. STEP 2: Press the MENU button. The component LED will blink once. MENU COMPONENT BUTTONS SELECT STEP 3: Press either the CBL or DVD button that you want to use as the source of OSD Control. The component LED will blink three times to confirm it is saved. Page 24

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Page 24
OSD (On-Screen Display) Control
“Punch Through”
This “Punch Through” enables you to program the
URC-A6 so that CBL or DVD OSD Controls
(MENU, GUIDE, INFO, EXIT, SEL and 4 Cursor
Controls) will also operate in other component
modes on the remote control.
STEP 1:
Press and hold the component button you
want to add OSD Control to, such as TV or DVD,
and the SELECT [SEL] button at the same time for
two seconds until the Component LED light turns
on.
IMPORTANT:
You have 30 seconds to perform
the next step while you are in programming mode.
If you do not press a button within 30 seconds, the
component LED light will turn off. The remote will
exit the programming mode and you will have to
start over.
STEP 2:
Press the MENU button. The component
LED will blink once.
STEP 3:
Press either the CBL or DVD button that
you want to use as the source of OSD Control. The
component LED will blink three times to confirm it
is saved.
SELECT
MENU
COMPONENT
BUTTONS