URC URC-A6 Owners Manual - Page 22

URC URC-A6 Manual

Get URC URC-A6 PDF manuals and user guides View all URC URC-A6 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Channel Control "Punch Through" This "Punch Through" enables you to program the URC-A6 so that either the Cable or TV Channel Controls (CHANNEL UP, DOWN, LAST, CHANNEL NUMBERS 0-9, +10 and ENTER) will also operate in other component modes on the remote control. STEP 1: Press and hold the component button you want to add channel control to, such as DVD or DVR, and the SELECT [SEL] button at the same time for two seconds until the Component LED light turns on. IMPORTANT: You have 30 seconds to perform the next step while you are in programming mode. If you do not press a button within 30 seconds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over. STEP 2: Press the CHANNEL UP button. The component LED light will blink once. COMPONENT BUTTONS SELECT CHANNEL UP STEP 3: Press either the TV or CBL button that you want to use as the source of channel control. The component LED will blink three times to confirm it is saved. Page 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Page 22
Channel Control “Punch Through”
This “Punch Through” enables you to program
the URC-A6 so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will also operate in other component
modes on the remote control.
STEP 1:
Press and hold the component button
you want to add channel control to, such as
DVD or DVR, and the SELECT [SEL] button at
the same time for two seconds until the
Component LED light turns on.
IMPORTANT:
You have 30 seconds to
perform the next step while you are in
programming mode. If you do not press a
button within 30 seconds, the component LED
light will turn off. The remote will exit the
programming mode and you will have to start
over.
STEP 2:
Press the CHANNEL UP button. The
component LED light will blink once.
STEP 3:
Press either the TV or CBL button that
you want to use as the source of channel control.
The component LED will blink three times to
confirm it is saved.
COMPONENT
BUTTONS
CHANNEL
UP
SELECT