TRENDnet TDM-E400 User's Guide - Page 70

TDM-E400 / TDM-C400 ADSL2+ Ethernet Modem Router User's Manual 7. If your ISP will assign the IP address from their DHCP server, click the Enable radio button in the Use DHCP field. When DHCP is enabled, the address you entered in the Conf. IP Address field will be requested from the DHCP server; the server many assign a different address if necessary. 8. If you are using the EoA interface to provide a routed connection to your ISP and you want the EoA interface to serve as the default route for Internet access for your LAN, ensure that the Default Route: Enable radio button is selected. (If you have more than on WAN interface, note that only one of them can be specified as the default route.) If you are using the interface to provide a bridged connection, then deselect this field. 9. In the Gateway IP Address field, enter the address of your ISP's access server. 10. Click . A confirmation page displays to confirm your changes. 11. Click to return to the EoA page and view the new interface in the table. f If the interface will be used to provide only a routed connection to your ISP, skip to step 16. f If the interface will be used to provide a bridged-only connection or a bridged-and-routed connection to your ISP, then continue with step 12 to enable bridging. 12. Click the Bridging tab. The Bridge Configuration page displays: Figure 23. Bridge Configuration Page The Bridge Configuration page provides links (shown in red) to the System Mode page, where you can enable or disable the corresponding bridging services. The Bridge Configuration page also displays a table for specifying the interfaces that support bridging. The table may be empty if bridging has not yet been configured. 70