Sony DWTP01/E4250 Product Information Document (Digirtal Wireless System Integ - Page 60

Configuring a DWX System Equipment Features DWX Network Accessories Remote Control Unit RMU-01 This is a 2.4 GHz antenna designed specifically for Cross Remote NT mode operation.  By connecting the unit and the DWR-R01D to a LAN, the transmitter remote control range can be extended, and up to 82 transmitters can be controlled remotely.  Using multiple RMU-01 units to enlarge the service area is also possible. Up to nine units can be used in one network system.  Power can be supplied either from the included AC adapter or from a PoE hub supporting PoE (Power Over Ethernet) or a PoE power supply.  Mounting to a microphone stand is possible. Bottom side     Hole for attaching the microphone stand Can be attached to the microphone stand (PF 1/2-inch thread) with this hole. To attach an NS 5/8-inch or a W 3/8-inch microphone stand, use the supplied screw adapter.  AC adapter connector and POWER indicator Connect the supplied AC adapter to the AC adapter connector to supply power to this unit. The POWER indicator lights up green while the power is supplied from the AC power connector or the LAN connector. For details on power supply to this unit, see "Power supply (PoE) for RMU-01".  LAN connector (RJ-45) This is a 100Base-TX/10Base-T connector for network connection. Communication speed automatically changes according to the connected device. Connect to a receiver such as DWR-R01D, Windows PC, or hub. When a PoE device including PoE hub is connected, the power is supplied through this connector. Computer requirements The computer on which to install Wireless Studio for use with the DWX system must meet the following requirements. Item Operating system (OS) CPU RAM Graphics card Available hard disk space Monitor resolution Other Condition Windows XP (SP3 or later) Windows Vista (SP1 or later) Windows 7 (32 bit/64 bit) 1 GHz or better recommended 1 GB or more recommended Video memory of 128 MB or greater recommended 1 GB or more 1024 × 768 pixels or better recommended English-language display capability 100Base-TX LAN card CD-ROM drive Ethernet hub information The RMU-01 supports PoE (Power over Ethernet). When the RMU-01 is connected to the LAN using an IEEE802.3af compliant PoE hub, the RMU-01 can be powered via the LAN cable. What is PoE (Power over Ethernet)? PoE allows powering a device over the Ethernet cables used in a LAN. Because data and power are routed through a single cable, installation of equipment is facilitated even in locations where providing a conventional power supply would be difficult. The RMU-01 can be powered from an IEEE802.3af compliant hub with PoE support, or by connecting a PoE power supply between a regular hub and the RMU-01. LAN cable information Use Category 5 or better LAN cable for connecting the RMU-01 or DWR-R01D to the computer. The maximum allowable cable run is 100 meters. If longer cable runs are required, use a hub between the computer and the RMU-01 or DWR-R01D. Depending on the connection configuration, use the following type of cable. Direct connection to computer: Crossover cable Connection via hub: Straight cable 60 Network System Configuration