Sharp BP-50M31 Operating Manual - Page 993

TROUBLESHOOTING►GENERAL PROBLEMS Check  Solution Are you printing on pre-punched paper? Does a message appear indicating the need for maintenance? Remove the paper, turn it over, and reload it. Using a different paper type may solve the problem. ■ Take care that the image does not overlap the punch holes. If the printed image overlaps the punch holes, smudges may appear on the reverse side of the paper following 1-sided printing, or on both sides following 2-sided printing. ■ Contact your dealer or nearest authorised service representative as soon as possible. ■ This may improve some states of paper curling. LOADING PAPER (page 1-11), HOW TO PLACE THE ORIGINAL (page 1-27) WHEN PRINTING ON THICK PAPER, THE PRINT RESULT IS DIRTY FROM THE 2ND PAGE ON Check Has the paper type been set correctly?  Solution ■ Set the correct paper type in the tray settings. Make sure that the following did not occur: • When using heavy paper, change the paper type in the tray settings to Heavy. (The image may disappear if rubbed.) • Paper other than heavy paper is being used, but heavy paper is selected in the tray settings. (This may cause creases and misfeeds.)  "Settings" → [System Settings] → [Common Settings] → [Paper Settings] → [Paper Tray Settings] → [Tray Registration] I DON'T KNOW HOW TO CHANGE THE OUTPUT TRAY Check Did you change the output tray?  Solution ■ When copying, you can select the output tray in normal mode. Tap [Output] in the base screen of normal mode. You can set the output tray in the screens. When printing, you can select the output tray in the printer driver. Click the [Finishing] tab in the printer driver, and select the output tray in [Output Tray]. The output tray is fixed and cannot be changed when some copy or print settings are selected. Some copy or print settings may be canceled when you change the output tray. 10-14