Sharp BP-50M31 Operating Manual - Page 843

SETTING MODE►SYSTEM SETTINGS Disable Switching of Display Order Disables to change the order of display (search number order, ascending, descending). Once set, the display sequence is not changed. The display order will remain fixed at the order that is in effect when this setting is enabled. Factory default settings: Disable Hold Setting for Received Data Print This function holds received faxes and Internet faxes in memory without printing them. The faxes can be printed by entering a password (factory default setting: 0000) with the numeric keys. Factory default settings: Disable Password When [Hold Setting for Received Data Print] is enabled, enter the password (4-digit number). These settings can only be configured when there is no received data in the machine memory (excluding data in a confidential or relay broadcast memory box). Default Verification Stamp This is used to enable or disable the default setting. Enable this to always affix the verification stamp on the original that has already been scanned using the automatic document feeder. Configure the setting for each of the following items: • E-mail/Scan/Data Entry • Fax/Internet Fax Factory default settings: Disable Erase Width Adjustment This is used to set the default erase width for erase function. Specify a value from 0" (0 mm) to 1" (25 mm) in increments of 1/8" (3 mm) for both edge erase and center erase. Factory default settings: Edge Clearance Width:1/2" (10mm), Center Clearance Width:1/2" (10mm) Time Specified Output of Received Data This function is available when the Received Data Image Check Setting is enabled. * This is displayed when a facsimile expansion kit or Internet fax expansion kit is installed. If "Time Specified Output of Received Data" is set to , this setting is grayed out. If "Change Password" or "Hold Setting for Received Data Print" is set to , the password entry field is grayed out. Factory default settings: Disable 9-77