Sharp BP-50M31 Operating Manual - Page 841

SETTING MODE►SYSTEM SETTINGS Common Settings Settings related to the image send function (E-mail, Internet fax, etc.) can be configured. The operation settings below apply to all image send functions. Condition Settings Hold settings for a while after scanning has been completed. Use this setting to hold the settings after scanning is completed (until Auto Clear Mode activates). Factory default settings: Disable Job Auto Start Time During Scanning Set the time at which transmission is automatically started even if the original is still being scanned. Factory default settings: 60 seconds Default Display Settings When resending by document filing or recalling by saved program settings that do not include an address, select from the following 6 types of base screens that appear. • E-Mail • Network Folder • FTP/Desktop • Internet Fax • Fax • Data Entry Factory default settings: Fax Address Book Default Selection Higher priority is given to the display of address book If image send mode is enabled, the Address Book is displayed in place of the initial screen of this mode. Factory default settings: Disable • In "Setting mode", if a default address has been configured by selecting [System Settings] → [Image Send Settings] → [Scan Settings] → [Default Address] → [Default Address Setting], the [Higher priority is given to the display of address book.] function cannot be used. Apply Addresses of Sending Modes Only When an address is selected from the address book, only the addresses displayed in narrowing mode are applied. Factory default settings: Enable Category Displayed as Default Select a category to be displayed with the default. • None • Frequent Use • Categories 1 to 32 Factory default settings: None Display all address type regardless of the mode being displayed currently. Displays all destinations regardless of the displayed mode when this setting is enabled. Factory default settings: Disable Enlarging the Address Book An enlarged address book list appears. Factory default settings: Enable 9-75