Panasonic PT-EW550 PT-EZ590 Series Operating Instructions - Page 39

Chapter 2 Getting Started - Removing/attaching the projection lens Removing/attaching the projection lens Removing and attaching procedures of the projection lens are same for both standard zoom lens and optional lens. Move the projection lens to the home position before replacing or removing the projection lens. (x page 54) Attention ff Replace the projection lens after turning off the projector. ff Do not touch the electrical contact of the projection lens. Dust or dirt may cause defective contact. ff Do not touch the surface of the projection lens with your bare hands. ff Before attaching the projection lens, remove the lens pad (only lens options models) and the lens cover attached to the projection lens. Removing the projection lens Remove the projection lens with the following procedure. i) Lens release button iii) ii) Projection lens 1) With the lens release button held down, turn the projection lens counterclockwise to the end and remove the projection lens. Attention ff Store the removed projection lens where it will be free from vibration and impact. ff If you cannot release the lock with lens release button held down, it indicates that the lens release button fixing screw is installed. Please remove the lens release button fixing screw. For details, refer to "When attaching the lens release button fixing screw". (x page 40) Attaching the projection lens Attach the projection lens with the following procedure. Guide groove Red marks Projection lens guide Guide groove Projection lens guide Fig.1 Projection lens Fig.2 1) Align the red mark on the projection lens with the red mark on the projector, and insert the projection lens to the end. (Fig. 1) 2) Turn the projection lens clockwise until it clicks. (Fig. 2) Attention ff Turn the projection lens counterclockwise to confirm that it does not come out. ENGLISH - 39