Panasonic AJ-HPX3100GJ Operating Instructions - Page 155
Error Codes, P2 Card Nearly Full, P2 Card Error, FAN STOP
View all Panasonic AJ-HPX3100GJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Maintenance and Inspections 11. P2 Card Nearly Full Display window indication WARNING lamp Tally lamp Viewfinder Warning tone Warning description One of the bars for remaining MEDIA capacity starts blinking. Blinks once per second while recording continues. Blinks once per second while recording continues. The P2 card remaining capacity indicator blinks. Beeps once per second while recording continues. The total remaining capacity of all the P2 cards is two minutes or less. Recording/ playback operation Continues to operate. Countermeasures Replace the cards. If there is an empty card slot, insert a new card. 12. P2 Card Error Display window indication WARNING lamp Tally lamp Viewfinder Warning tone Displays "00:00:00:11" in the time code display. The window continues to flash until the next operation, even after stopping record and playback. If the error occurs during recording, the lamp flashes four times per second for a period of about three seconds. The lamp does not light if the error occurs during playback. If the error occurs during recording, the lamp flashes four times per second for a period of about three seconds. The lamp does not light if the error occurs during playback. A flashing "CARD ERR ¢" appears. In the actual indication the ¢ is replaced by the slot number of the P2 card that triggered the error. If the error occurs during recording, the tone sounds four times per second for a period of about three seconds. The tone does not sound if the error occurs during playback. Warning description An error has occurred while recording data to or playing data from a P2 card. Recording/ playback operation Stop recording or playback. After recording is stopped, the P2 card where error occurs is write protected. Countermeasures Replace the affected P2 card. 13. FAN STOP Display window indication No display. WARNING lamp Blinks 4 times per second. Tally lamp No display. Viewfinder The FAN STOP indicator blinks while recording continues. Warning tone It does not sound. Warning description The fan is at rest because something is wrong with it. Alternatively, the FAN MODE item is set to "OFF". The menu item FAN MODE is found in the screen on the OPTION MENU page. Recording/ playback operation If the camera-recorder operates with the fan stopped, then the temperature inside rises. While the camera-recorder continues to operate, clips may not be recorded or played back properly. Countermeasures Immediately stop using the camera-recorder and consult your distributor. Error Codes The following error codes are displayed in the display window if an error occurs in the camera: Confirm the type of warning and refer to the details in the [Warning Description Tables] (page 153) for countermeasures. Code No. Description Type of warnings E-11 E-27 E-30 E-34 E-38 E-3F E-40 E-63 E-6F 00:00:00:11 Video initialisation error Recording control error P2 card removal error LCD microcontroller error P2 streaming microcontroller error Microprocessor error in the camera control circuit. Image sequence, GENLOCK input signal or SDI input signal error Something is wrong with the system control microprocessor. Reference signal error. Errors such as recording to P2 card error 1. System Errors 1. System Errors 2. Card removal error 1. System Errors 1. System Errors 1. System Errors 5. Image Sequence Error, 6. Corruption of Standard Signal 1. System Errors 1. System Errors 7. Recording Error, 8. Number of Clips Exceeded, 12. P2 Card Error Maintenance and Inspections: Warning System 155