Lantronix EDS3000PR User Guide - Page 39
To Con Network Interface Settings, Using Web Manager, Using the CLI, Using XML
View all Lantronix EDS3000PR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
6: Network Settings To Configure Network Interface Settings Using Web Manager To view Wired Network (eth0) Interface status, on the Network page, select Wired Network > Interface. To configure Wired Network (eth0) Interface settings, on the Network page, select Wired Network > Interface > Configuration. Using the CLI To enter the command level: enable > config > if 1 Using XML Include in your file: Link Status and Configuration Figure 6-4 Wired Network (eth0) Ethernet Link Status displays the wired network's link status information. This same information is configurable on the Wired Network (eth0) Link Configuration page, shown in Figure 6-5 Wired Network (eth0) Link Configuration. Table 6-6 Wired Network (eth0) Link Configuration describes the configuration information. Figure 6-4 Wired Network (eth0) Ethernet Link Status Figure 6-5 Wired Network (eth0) Link Configuration Table 6-6 Wired Network (eth0) Link Configuration Setting Speed Duplex Description Select the Ethernet link speed. Choices are Auto, 10Mbps, and 100Mbps. Default is Auto. Select the Ethernet link duplex mode. Choices are Auto, Half, and Full. Default is Auto. Notes: When speed is Auto, duplex must be Auto or Half. When speed is not Auto, duplex must be Half or Full. EDS3000 Device Server User Guide 39