Invacare CXE Owners Manual - Page 84
Installing/Replacing Seat Positioning Straps
View all Invacare CXE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
SECTION 8-SEAT 6. Install the new back upholstery, if so equipped, onto the wheelchair. Refer to Replacing Standard Back Upholstery on page 63 or refer to Replacing Recliner Back/ Headrest Upholstery on page 66. Wheelchair Frame Crossmembers Washer Hex Screw Washers FIGURE 8.6 Changing Seat Width - Rigid Frames Installing/Replacing Seat Positioning Straps NOTE: For this procedure, refer to FIGURE 8.7 on page 85. Installing Seat Positioning Straps 1. Remove the hex screw and locknut that secures the back cane to the back plate. 2. Position the seat positioning strap against the back plate. 3. Install the hex screw through the seat positioning strap, coved spacers and back cane. 4. Securely tighten the seat positioning strap to the wheelchair with the locknut. 5. Repeat STEPS 1‐4 for opposite side. Replacing Seat Positioning Straps 1. Remove the hex screw, locknut and seat positioning strap from the back plate of the wheelchair frame. 2. Discard existing seat positioning strap. 3. Install the hex screw through the seat positioning strap, coved spacers and back cane. 4. Securely tighten the seat positioning strap to the wheelchair with the locknut. 5. Repeat STEPS 1‐4 for opposite side. Compass™XE and Allegro® 84 Part No 1127114