Invacare CXE Owners Manual - Page 37
Adjusting Footrest Height
View all Invacare CXE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Adjusting Footrest Height SECTION 5-FRONT RIGGINGS Height Adjustment Ranges FOOTREST TYPE ADJUSTMENT RANGE 60° 13-17-inches 70° 13-17-inches 90° 5-8-inches 90° 5-11-inches (with 3-inch extension) NOTE: If using ANY type of extension with the adjustable flip‐up footplate. Refer to Adjusting Adjustable Angle Flip‐Up Footplates on page 39. 60°, 70° and 90° Taper NOTE: For this procedure, refer to FIGURE 5.3. 1. Remove the footrest from the wheelchair.Refer to Installing/Removing Swingaway Footrest on page 35. 2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting tube until the desired footrest height is achieved. Hex Screw Coved Spacer Footrest Footrest Upper Support Mounting Tube 3. Reassemble the hex screw and coved spacer through the footrest upper support and mounting tube (FIGURE 5.3). FIGURE 5.3 Adjusting Footrest Height 60°, 70° and 90° Taper 4. Securely tighten the hex screw and coved spacer. 5. Install the footrest assembly onto the wheelchair. Refer to Installing/Removing Swingaway Footrest on page 35. 6. Repeat STEPS 1‐5 for the opposite side of the wheelchair, if necessary. 70° MFX, 90°, 70° LIFT and 90° LIFT Footrests NOTE: For this procedure, refer to FIGURE 5.4 on page 38. 1. Remove any accessories that are attached to the footrests. 2. Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support. 3. Reposition the footplate to the desired height. Part No 1127114 37 Compass™XE and Allegro®