Invacare CXE Owners Manual - Page 104
Adjusting the Quad-Release Axle
View all Invacare CXE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
SECTION 10-WHEELS 6. Flip the handle of the quad‐release axle down to release the detent pin ensuring that the locking pins are fully released. 7. If detent pin does not fully release, proceed to adjusting in Installing/Adjusting the Quad‐Release Axle. 8. Repeat STEPS 1‐7 for the opposite rear wheel. Quad-Release Axle Axle Mounting Plate Allen Screw Locking Collar Rear Wheel Hub FIGURE 10.3 Installing the Quad-Release Axle Adjusting the Quad-Release Axle NOTE: For this procedure, refer to FIGURE 10.4 on page 105. In and/or Out 1. Remove rear wheel and the quad‐release axle. Refer to Removing/Installing Rear Wheels on page 101. 2. Loosen the locking screw. 3. Make the following adjustments: A. If the quad‐release handle is not releasing the locking pins completely, rotate the quad‐release handle approximately one‐quarter turn clockwise. B. If the quad‐release handle hits the spokes of the rear wheel when assembled, rotate the quad‐release handle approximately one‐quarter turn counterclockwise. 4. Tighten the locking screw. 5. Reinstall the rear wheel and quad‐release axle onto the wheelchair. Refer to Removing/Installing Rear Wheels on page 101. ƽ WARNING Make sure the detent pin and locking pins of the quad-release axle are fully released BEFORE operating the wheelchair. Keep locking pins clean. 6. Flip the handle of the quad‐release axle down to release the detent pin ensuring that the locking pins are fully released. 7. Repeat the above procedures until the quad‐release axle locks correctly. Compass™XE and Allegro® 104 Part No 1127114