IBM x3455 User Manual - Page 50
Replacing, front, drive - review
![]() |
UPC - 000435947109
View all IBM x3455 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
6. If you are replacing the removed drive with a new drive, slide the drive mounting clip to remove it from the drive. Place the drive mounting clip on a flat, static-protective surface. Keep the drive mounting clip available for attachment to the new drive. CD or DVD drive Drive retention clip Slide the clip into place against the drive If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on page 51. Replacing the front hard disk drive Locate the documentation that comes with the hard disk drive and follow those instructions in addition to the instructions in this section. Also, review the considerations at the beginning of "Installing a drive in the rear hard disk drive cage" on page 30 for additional information. If a CD or DVD drive is installed, the front hard disk drive cage is under the CD or DVD drive assembly. Therefore, you must remove the CD or DVD drive assembly to access the front hard disk drive cage. Before you install a non-hot-swap hard disk drive, read the following information: v See the documentation that comes with the drive for any cabling instructions. v Route the cable before you install the drive. Do not block the airflow from the fans or air baffles. 36 System x3455 Types 7984 and 7986: User's Guide
![](/manual_guide/products/ibm-798431u-user-manual-a0342ee/50.png)