Dell XPS 13 9370 XPS 13 Service Manual - Page 30

Replacing the headset port, Procedure, Post-requisites

Get Dell XPS 13 9370 PDF manuals and user guides View all Dell XPS 13 9370 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 30 highlights

18 Replacing the headset port NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance. Procedure 1. Place the headset port in its slot on the palm-rest assembly. 2. Replace the screw (M1.6x3) that secures the headset port to the palm-rest assembly 3. Reconnect the headset-port cable to the system board. 4. Using the alignment posts, press the right display hinge down on the palm-rest assembly aligning the screw holes on the display hinge to the screw holes on the palm-rest assembly. 5. Replace the two screws (M2.5x4) that secure the display assembly to the palm-rest assembly. Post-requisites Replace the base cover. 30 Replacing the headset port

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
Replacing the headset port
NOTE:
Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in
Before working inside your computer
. After working inside your computer, follow the instructions in
After
working inside your computer
. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance
.
Procedure
1.
Place the headset port in its slot on the palm-rest assembly.
2.
Replace the screw (M1.6x3) that secures the headset port to the palm-rest assembly
3.
Reconnect the headset-port cable to the system board.
4.
Using the alignment posts, press the right display hinge down on the palm-rest assembly aligning the screw holes on the display hinge
to the screw holes on the palm-rest assembly.
5.
Replace the two screws (M2.5x4) that secure the display assembly to the palm-rest assembly.
Post-requisites
Replace the
base cover
.
18
30
Replacing the headset port