Bosch HBE5451UC Installation Instructions - Page 7
Install Appliance
View all Bosch HBE5451UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Flush installation 7RS9LHZ UHYHDO UHYHDO FOHDWV FOHDWV IOXVKLQVHW GHSWK èʌ¼ʓʘ ë PP 6LGH9LHZ UHYHDOFOHDWV èʌ¼ʓʘ * Flush installation requires a 3/16" (5 mm) high x 2115/16" (557 mm) wide x 221/16" (560 mm) deep baseplate underneath the unit body. ʐ¼ʓʘ IOXVKFXWRXW KHLJKW PP Install Appliance Electrical Installation All model ovens on the front cover are dual rated, designed to be connected to either 208/240V AC, 50/ 60 Hz, 4 wire, single-phase power supply. Model HBE5451UC Dedicated circuit required 20 AMP The electrical supply should be a 4-wire single-phase AC. Install a suitable conduit box (not furnished). An appropriately-sized, UL-listed conduit connector must be used to correctly attach the conduit to the junction box. NOTICE: Local Codes may vary; installation, electrical connections and grounding must comply with all applicable local codes. If local codes permit grounding through the electrical supply neutral, connect both the white neutral wire and the bare ground wire from the oven to the white neutral electrical supply wire. 9 CAUTION ▯ The appliance must be disconnected from the power supply during all installation work. ▯ The appliance must only be connected with the power cable provided. ▯ Protection against contact must be ensured by the installation. Electrical Connection The four-wire connection is preferred, but where local codes permit, the three wire connection is also acceptable. 9 WARNING When connected to a 4 or 5-wire, 120/208-Volt 3phase power supply; the phase C conductor is not required for the operation of the appliance. 7