Black & Decker LSTE522 Instruction Manual - Page 10

replacement spool and RC-100-P replacement spool cap. Reload nylon line (either bulk or prewound replacement spool) as shown in this manual. • USE ONLY .065 inch (1.65 mm) DIAMETER ROUND NYLON MONOFILAMENT LINE. Do not use serrated or heavier gauge line, as they will overload the motor and cause overheating. This line is available at your local dealer or authorized service center. • Other replacement parts (guards, spool caps, etc.) are available through BLACK+DECKER service centers. To find your local service location call: 1-800-544-6986 or visit www.blackanddecker.com. WARNING: The use of any accessory not recommended by BLACK+DECKER for use with this appliance could be hazardous. REPLACING THE SPOOL • Remove battery from appliance. • Depress the tabs (21) and remove the spool cap (22) from the spool housing (12) (figure O). • For best results, replace spool with BLACK+DECKER model # AF-100. • Grasp empty spool with one hand and spool housing with other hand and pull spool out. • If lever (25) or spring (26) in the base of the housing (figure R) become dislodged, replace in correct position before inserting new spool into housing. • Remove any dirt and grass from the spool and housing. results, factory wound spools are recommended. To install bulk line, follow the steps below: • Remove battery from appliance. • Remove the empty spool from the appliance as described in "REPLACING THE SPOOL." • Remove any remaining cutting line from the spool. • Make a fold at the end of the cutting line at about 3/4 inch (19mm)(28). Feed the cutting line into one of the line anchoring slots (29) as shown in figure S. S 28 29 • Insert the 3/4 inch (19mm) end of the bulk line into the hole (30) in the spool adjacent to the slot as shown in figure T. Make sure the line is pulled tight against the spool as shown in figure T. T 31 30 R 26 27 P2 25 • Unfasten the end of the cutting line and guide the line into the eyelet (P2) figure P. • Take the new spool and push it onto the boss (27) (figure R) in the housing. Rotate the spool slightly until it is seated. The line should protrude approximately 5-3/8 inches (136mm) from the housing. • Align the tabs on the spool cap with the slots in the housing (figure Q). • Push the cap onto the housing until it snaps securely into place. • Wind the cutting line onto the spool in the direction of the arrow on the spool. Make sure to wind the line on neatly and in layers. Do not crisscross (figure U). • When the wound cutting line reaches the recesses (31), cut the line. (figure T). • Fit the spool onto the appliance as described in "REPLACING THE SPOOL". U REWINDING SPOOL FROM BULK LINE (USE ONLY .065 IN. ROUND DIAMETER LINE) Bulk line is also available for purchase from your local retailer. NOTE: Hand wound spools from bulk line are likely to become tangled more frequently than BLACK+DECKER factory wound spools. For best MAINTENANCE WARNING: To avoid serious injury, remove the 10