Beko BIM24400 User Manual - Page 14
Brown, Green, Yellow, Merminal, Block, Supply
View all Beko BIM24400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Aa DANGER: I • The product must be connected to the mains supply only by an authorised and qualified person. Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons. DANGER: The power cable must not be clamped, bent or rapped or come into contact with hot parts of the product. A damaged power cable must be replaced by a qualified electrician. Otherwise, there is risk of electric shock, short circuit or fire! • Connection must comply with national regulations. • The mains supply data must correspond to the data specified on the type label of the product. Open the front door to see the type label. • Power cable of your product must comply with the values in "Technical specifications" table. ( DANGER: I Before starting any work on the electrical installation, disconnect the product from the mains supply. There is the risk of electric shock! Connecting the power cable 1. If a power cable is not supplied together with your product, a power cable that you would select from the table (Technical specifications, page in accordance with the electrical installation at your home must be connected to your product by following the instructions in cable diagram. If it is not possible to disconnect all poles in the supply power, a disconnection unit with at least 3 mm contact clearance (fuses, line safety switches, contactors) must be connected and all the poles of this disconnection unit must be adjacent to (not above) the product in accordance with IEE directives. Failure to obey this instruction may cause operational problems and invalidate the product warranty. dditional protection by a residual current ircuit breaker is recommended. 4. Connect the cables according to the supplied diagram. MERMINAL BLOCK BROWN GREEN / YELLOW SUPPLY CORD 5. After completing the wire connections, close the terminal block cover. 6. Route the power cable so that it will not contact the product and get squeezed between the product and the wall. Power cable must not be longer than 2 m because of safety reasons. Installing the product 1. Slide the oven into the cabinet, align and secure it while making sure that the power cable is not broken and/or trapped. Secure the oven with 2 screws as illustrated. 2. Open the terminal block cover with a screwdriver 3. Insert the power cable through the cable clamp below the terminal and secure it to the main body with the integrated screw on cable clamping component. 14/EN