2010 Yamaha Motorsports Apex Owners Manual - Page 34
2010 Yamaha Motorsports Apex Manual
Page 34 highlights
Control functions Rebound damping setting: Minimum (soft): 22 click(s) in direction (b)* Standard: With the adjusting dial fully turned in direction (a) Maximum (hard): With the adjusting dial fully turned in direction (a) * With the adjusting dial in the standard position ESU11046 TIP Use the special wrench in the owner's tool kit to make this adjustment. 2. 3. Loosen the locknut. To increase weight transfer, turn the adjuster in direction (a), and to decrease weight transfer, turn it in direction (b). WARNING! Never adjust the control rod beyond the range of the scale on the special wrench, otherwise the control rod could be damaged, which could lead to an accident or injury. [EWS00181] Adjusting the control rods The weight transfer can be adjusted by turning the adjuster on the control rod (RX10R / RX10LT) or the adjusting nuts on the control rods (RX10MT). RX10R / RX10LT 1. Check the control rod length using the scale on the special wrench as shown. TIP In order to obtain a precise measurement, the special wrench corner should touch the control rod adjuster, and the locknut must be turned so that one of its notches aligns with the wrench allowing the wrench to fit horizontally on the control rod. 1. Locknut 2. Control rod adjuster 4. Tighten the locknut while holding the adjuster in place. 1 Min 3 Max 4 TIP Make sure that the special wrench is securely fitted on the locknut. 2 1. 2. 3. 4. 5. 5 Special wrench corner Control rod adjuster Scale range Special wrench Control rod length 28