2008 Polaris Sportsman 800 EFI Touring Owners Manual - Page 136

2008 Polaris Sportsman 800 EFI Touring Manual

Page 136 highlights

TROUBLESHOOTING Possible Cause Out of fuel Kinked or plugged fuel vent line Water is present in fuel Fouled or defective spark plug(s) Worn or defective spark plug wires Incorrect spark plug gap or heat range Loose ignition connections Low battery voltage Incorrect fuel Clogged air filter Reverse speed limiter malfunction Electronic throttle control malfunction Other mechanical failure Overheated engine Engine Stops or Loses Power Solution Refuel, cycle key to ON position three times for 5 seconds each, then start Inspect and replace Replace with new fuel Inspect, clean and/or replace spark plug(s) See your dealer Set gap to specs or replace plug Check all connections and tighten Recharge the battery to 12.8 VDC Replace with fresh recommended fuel Inspect and clean or replace See your dealer See your dealer See your dealer Clean radiator screen and core, clean engine exterior, see your dealer Engine Overheating Possible Cause Debris lodged in screen Solution Remove and clean the screen. Pull on the top portion of the screen, then remove the lower portion. Use a garden hose to flush any debris from the radiator fins. NOTE: High pressure washers can deform the radiator fins and reduce cooling efficiency. Plugged Radiator 136

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149

136
TROUBLESHOOTING
Engine Stops or Loses Power
Engine Overheating
Possible Cause
Solution
Out of fuel
Refuel, cycle key to ON position three
times for 5 seconds each, then start
Kinked or plugged fuel vent line
Inspect and replace
Water is present in fuel
Replace with new fuel
Fouled or defective spark plug(s)
Inspect, clean and/or replace spark
plug(s)
Worn or defective spark plug wires
See your dealer
Incorrect spark plug gap or heat range
Set gap to specs or replace plug
Loose ignition connections
Check all connections and tighten
Low battery voltage
Recharge the battery to 12.8 VDC
Incorrect fuel
Replace with fresh recommended fuel
Clogged air filter
Inspect and clean or replace
Reverse speed limiter malfunction
See your dealer
Electronic throttle control malfunction
See your dealer
Other mechanical failure
See your dealer
Overheated engine
Clean radiator screen and core, clean
engine exterior, see your dealer
Possible Cause
Solution
Debris lodged in screen
Remove and clean the screen. Pull on the
top portion of the screen, then remove the
lower portion.
Plugged Radiator
Use a garden hose to flush any debris
from the radiator fins. NOTE: High pres-
sure washers can deform the radiator fins
and reduce cooling efficiency.