2008 Polaris Hammer Owners Manual - Page 130
2008 Polaris Hammer Manual
Page 130 highlights
Seat Removal and Installation WARNING MAINTENANCE The seat mounting screws are located under the three cowl grommets at the rear of the seat and are accessed from the top after removing the seat cowl. Always make sure the seats are securely fastened before riding the motorcycle. A loose seat could cause a sudden shift in riding position, causing loss of control. Seat Removal 1. Remove the passenger seat cowl by pulling directly upward on both sides of the cowl evenly (see arrows). 2. Remove the (3) socket head screws from each side of the seat using a 5mm hexagonal wrench. 3. Lift the rear of the seat and pull rearward to disengage the tab at the front of the seat. 4. Remove the seat. 1 2 Seat Installation 1. Remove Rear Cowl 2. Remove (3) screws. 3. Lift Rear of Seat, Pull Rearward 1. Slide the tongue of the seat into the frame's receiver at rear of fuel tank. 2. Align the screw holes at the rear of seat. 3. Ensure the front seat mount is engaged in the front receiver, then install the screws and tighten to 57 in. lbs. (6.8 Nm). 4. Reinstall passenger seat cowl. 125