1997 Oldsmobile Achieva Owner's Manual - Page 142
1997 Oldsmobile Achieva Manual
Page 142 highlights
FWD (2): Press this button to advance quickly to another part of the tape. Press the button again to return to playing speed. The radiowill play the last-selected station while the tape advances. You may select stations during FWD operation by using TUNE. this button again to stop scanning. The sound will mute, SCAN will appear on the display and the tape direction arrow will blink while scanning. AM-FM: Press this button to play the radio when tape a is in the player. The tape will stop but remain in the player. PROG (3): Press this button to play the other sideof the tape. 10 (4): Press this button to reduce background noise. license from Dolby Laboratories Licensing Corporation. Dolby and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. TAPE AUX: If you have a tape inserted and the radio is playing, press TAPE AUX to play your tape. To return to the radio while a tape is playing, press AM-FM. The Note that the double-D symbol will appear on the display. inactive tape will remain safely inside the radio for future listening. Dolby@Noise Reduction is manufactured under a TONE: Press this button to selecta tone while playing a cassette. The tone will be automatically set whenever you play a cassette tape. EJECT Press this button to remove the tape. The radio will play. EJECT may be activated with either the ignition or radiooff. Cassettes may be loaded with the radio and ignition off if this button is pressed first. If you leave a cassette tape in the player while listening to the radio, it may become warm. CLN: If this message appears on the display, the cassette tape player needs to be cleaned. It will still play tapes, but you should clean it as soon as possible to prevent damage to the tapes and player. See "Care of Your Cassette Tape Player" in the Index. After you clean the player, press and hold EJECT for fiveseconds to reset the CLN indicator. The radio will display --- to show the indicator was reset, SEEK: Press the up or downarrow to search for the next or previous selection on the tape. Your tape must hme at least three seconds silence between each of selection for SEEK to work. After the selection has been playing for at least eight seconds, press the SEEK down arrow to return to the beginning of the selection. SCAN: Press this button to listen to each selection for a few seconds. The tape will go to the next selection, stop for a few seconds, then go on to the next selection. Press 3-12