2006 Honda Ridgeline Owner's Manual - Page 245
2006 Honda Ridgeline Manual
Page 245 highlights
Lights 4. Install the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place, and clip the end into the slot. 5. Install the rubber weather seal over the back of the headlight assembly. Make sure it is right side up. 6. Push the electrical connector onto the new bulb. Make sure it is connected securely. Turn on the headlights to test the new bulb. Replacing a Front Turn Signal/ Hazard/Parking Light Bulb 1. To change the passenger's side bulb, start the engine, turn the steering wheel all the way to the left, and turn off the engine. To change the driver's side bulb, turn the steering wheel to the right. HOLDING CLIPS 3. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. 4. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms. 2. Use a flat-tipped screwdriver to remove the two holding clips from the inner fender, and pull the inner fender cover back. 246