Xerox 6180N Using LCDS Print Description Language - Page 322

Specifying print format parameters Default NO OUTPUT STAPLE parameter: points to note • The STAPLE command must be specified in the initial JDL/ JDE, or the JDL/JDE DJDE record must be the first record processed. If there is a banner page in front of the JDL/JDE DJDE record, the STAPLE command is ignored. • If the NTO1=YES and STAPLE=YES parameters are specified, the system overrides NTO1=YES with NTO1=NO and places an error message in the listing file when the JSL is compiled. • Individual sheets cannot be offset when they are coded in the JSL. To maintain consistent face-up orientation while stitched and unstitched jobs are delivered to the stacker, you may print unstitched sets N-to-1, provided that the system does not encounter the override conditions that have been defined. • DP 75/90 systems: Jobs greater than 50 pages are not stapled. The default behavior is to fault the job, with no error message displayed. If you want the job to print without any finishing, do the following in the Overprint Finishing section of the Finishing window: 1. Select [Print Job Unfinished]. 2. Select [Check Set-Size] before Printing. OUTPUT STOCKS Identifies the stockset and its associated stocks that will be used for a report. This stockset file (STOCKSETNAME.STK) must have been created previously via compilation of a JSL and must currently be stored in the "lcds" resource folder. Syntax OUTPUT STOCKS = stocksetname Options Table 4-75. OUTPUT STOCKS parameter options and definitions Option Definition stocksetname Specifies the stockset to be used for the job. Default No default. 4-82 Using LCDS Print Description Language