Viper 3303 Owner Manual - Page 39

Using the 1-way Companion remote The 1-way companion remote commands the system features as shown in the previous table, but only transmits and does not provide feedback as with the 2-way remote control. Siren chirps and parking light flashes are used to indicate that a command has been received and activated as described in the Basic Commands and Advanced Commands sections. Accessing Commands Similar to the Responder LC remote, basic commands are performed when a command button is pressed directly. To perform advanced commands press the button one to four times to access function levels. For example; x4 in the table implies pressing four times to reach level 4. The transmit LED flashes in groups of 1 to 4 for a few seconds to indicate the respective level. Press the desired command button while the transmit LED is flashing to perform the command. Button Auto Lock When on, the remote control buttons lock if more than 20 seconds lapses between button presses. If a button is pressed when locked, the remote control appears to be non-operational and will not transmit a command or illuminate the transmit LED. To unlock the buttons; press the button followed by the button. Car Select Car 2 must first be turned on (See Remote Features menu under Programming section below to turn on). Press and hold the button for 3 seconds. The remote flashes the transmit LED once or twice to indicate the selected car is 1 or 2. Release the button, then press and release while the transmit LED flashes to perform car select. Once the car is selected a command 36 © 2009 Directed Electronics. All rights reserved.