Sharp XG-PH70X XG-PH70X Operation Manual - Page 37
Controlling the Projector by a Computer
![]() |
UPC - 074000365117
View all Sharp XG-PH70X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Controlling the Projector by a Computer When the RS-232C terminal on the projector to the RS-232C serial terminal on the computer, or when the LAN terminal on the projector to the LAN terminal on the computer, the computer can be used to control the projector. Refer to the "SETUP MANUAL" contained on the supplied CD-ROM for details. When connecting to a computer using an RS-232C serial control cable Computer Side view Connections To RS-232C terminal RS-232C serial control cable (cross type, commercially available) To RS-232C terminal Note • The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details. • Refer to "SETUP MANUAL" contained on the supplied CD-ROM for the RS-232C specifications and commands. Info • Do not connect the RS-232C cable to a terminal other than the RS-232C terminal on the computer. This may damage your computer or projector. • Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer. When connecting to the LAN terminal using a LAN cable Hub or computer LINK LED (green) Illuminates when linked. TX/RX LED (yellow) Illuminates when transmitting/receiving data. Side view To LAN terminal To LAN terminal * To ensure safety, do not connect the LAN terminal with any cables such as a telephone line that may cause excessive voltage. LAN cable (Category 5 type, commercially available) Note • When connecting to a hub, use straight-through Category 5 (CAT.5) type cable (commercially available). • When connecting to a computer, use cross-over Category 5 (CAT.5) type cable (commercially available). -35
![](/manual_guide/products/sharp-xgph70x-xgph70x-operation-manual-8fb9d61/37.png)